Custom Search
Free Ads with Adsense Revenue Sharing

SEARCH HERE

OFFER MONEY FROM ZERO

Sunday, January 3, 2010

PROBLEM - NO DISPLAY ON THE COMPUTER -RAMM

In previous articles, we have learned what reason if the computer does not produce any damage to the display because the Power Supply.

In the article, what happens if the damage is not the  Power Supply ?.

There are two reasons that can be given category, kategory easy and difficult categories.

We take easy first category,

This problem occurs commonly caused by Ram, the most easily if the computer is turned on and you will hear sounds such as Tik-tik-tik, so here is the main cause of Ram.  Its' was easy  step..


A. Open the computer casing

i. Remove from Ram Slots

ii. Replace the ram and try to switch the computer as usual.

ii.If your board have more than one slot, install Ram into the next slot.

iv. If you used  are two Ram, was checking out one by one to cause damage.

If you get the same problem, try cleaning your Ram used eraser.

Before you turn on you computer, make sure your is grip in the slot..

B. See image below,  how to install or remove the Ram from the slot.



-First you must unlock the tabs. The nearest one is unlocked, while the other two are still locked.







- Line up the Ramm with the bank, taking care to line up the notches with the corresponding features on the banks.









- Then push the DIMM straight down. This may take a significant amount of force. The tabs should pop back up when you do this.












After you check your Ram, but your computer still no hace any display, maybe your computer have a problems with Mainboard or Processor. 


We will learn it in next article.


See Ya..




0 comments:

Post a Comment

There was an error in this gadget

FOLLOWER

 

©2009 MONEY FROM ZERO | by TNB